Solar Panel LED LightingAll Purpose Mfg. Inc.

Back to Path Lighting

220 WATT SOLAR POWERD 12 VOLT 25 WATT LED PATH LIGHTING
Custom 25 Watt LED
Solar Illumination with LED

Redondo Beach Design Build

APMFG has a Class A contractors license with a full manufacturing plant. This allows APMFG to be very competitive in the bidding process.
The entire design was developed by APMFG, structural poles, LED lighting fixtures and our Solar engineer which sized the solar capacity required. Outside engineering team stamped the Structural and Electrical plans. All footings have epoxy coated rebar and special concrete mixes were added for extra strength.
220 watt solar panels
EPU Controllers timers gel batteries
25 watt LED MCE high power

CONSTRAINTS

The lighting had to be designed to illuminate a path area of 18ft x 60ft at an angle of 35 degrees 5 feet away and 10 feet high totaling 32 units.
The LED lighting had to illuminate 5 foot candles in the center, and from the center to 30 ft diameter it had to illuminate 1.25 ft candles and from the center to 60 ft diameter illuminate .25 ft candles. APMFG exceeded the foot candle illumination.

The illumination sequence was most difficult: Operating times were as follows From 5:00 PM until 11:00PM 50% of the LED lighting had to turn off and at 5:00AM back to100% until 7:00 AM.

 
Construction

SPECIFICATIONS

Two Mitsubishi 110 Watt Panels
Two 85 AMP/HR Gel Batteries
Morningstar 20
Timer Controller
Four 20 Amp Breakers
36 Hour Battery Backup
10 Foot Grounding Rod
Heavy Duty Custom Design APMFG
Aluminum LED Light Fixtures Fabrication of structural poles and solar rack system